Bmr-suspension TCA026 User Manual download pdf

TRAILING ARMS

TCA026 – 2008-PRESENT PONTIAC G8, 2010-PRESENT CAMARO

Tools required:

o 3/8” drive ratchet

o 18mm socket

o 18mm wrench

Installation:

1. Lift the vehicle until the wheels are off the ground.

Support with jack stands. NOTE: Installation is

much simpler with wheels/tires removed however

it is not necessary to remove them.

2. Start with the outer bolt. Hold the nut with the

wrench and loosen the bolt using the socket.

3. Using the socket, remove the front trailing arm bolt. NOTE: the nut is welded to the

subframe and is not necessary to hold with a wrench.

4. Remove both bolts and remove the trailing arm. NOTE: outer bolt can only be

removed if the suspension is in the full droop position.

5. Install the BMR trailing arm back into the original position and insert the bolts.

6. Repeat steps 2-5 on the other side.

7. Torque bolts to 80 ft/lbs.

8. Lower vehicle.

9. Grease both fittings approximately 3-4 pumps or until you see the bushing just start to

bulge. NOTE: it is recommended to grease the bushings with the vehicle lowered and

the suspension compressed. Failure to do so may result in suspension binding and/or

premature bushing wear.

12/04/2008

1 2

1 TRAILING ARMS TCA026 – 2008-PRESENT PONTIAC G8, 2010-PRESENT CAMARO Tools required: o 3/8” drive ratchet o 18mm socket o 18mm wrench Installati

Page 2

2 This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such, Buyer assumes al

No comments

Bmr-suspension TCA026 User Manual