Bmr-suspension TR004 User Manual download pdf

ADJUSTABLE TOE RODS

TR004 – 2010-present Camaro

RECOMMENDED TOOLS:

Hydraulic Jack and stands

Wrenches: 10mm, 22mm,, 1-1/8”

Sockets: 18mm, 22mm, 15/16”

INSTALLATION:

1. Lift vehicle and support with stands under the frame rails.

2. Remove the rear wheels/tires.

3. Pop the ABS wire loose from the OE toe rod by squeezing the

retaining clips from the backside. (Image 1)

4. The inner bolt of the toe rod controls alignment and must be marked

before loosening in order to maintain proper alignment settings

during re-assembly. Using a paint marker or chalk, mark the cam

washer and subframe as shown in Image 2.

5. Due to fuel tank interference, the drivers’ side inner toe rod bolt

cannot be removed without lowering the cradle. Support the cradle

as shown in Image 2b below. Using a 15/16” socket, remove the

front two cradle bolts and loosen the rear bolts. The cradle should

lower enough to remove the bolts.

6. Using a 22mm wrench and 22mm

socket, remove the inner bolt.

7. Using an 18mm socket remove the outer

bolt and then remove the toe rod.

8. Lay the BMR adjustable Toe Rod over

the top of the factory toe rod as shown in

Image 3 on the following page. Adjust

it until it is the same length as the OE toe

rod. The easiest way to do this is to

insert the factory bolts through both toe

rods to verify proper length. Once it is

the same length, tighten both jam nuts.

9. Install the BMR Toe Rod using the OE

bolts.

1 2

ADJUSTABLE TOE RODS TR004 – 2010-present Camaro RECOMMENDED TOOLS: Hydraulic Jack and stands Wrenches: 10mm, 22mm,, 1-1/8” Sockets: 18mm, 22mm, 1

ADJUSTABLE TOE RODS (Cont.) TR004 – 2010-present Camaro 10. Using a 10mm wrench rotate the inner bolt until the cam washer lines up with the mar

No comments

Bmr-suspension TR004 User Manual